I anchor my winch on it to pull just a little lean off not much.
Sep 01, The back lean is the distance from this point along the intended direction of fall to the apex of the planned undercut. The apex will be the front of the hinge and the pivot point for the falling stem. The weight of the tree must be brought over this pivot point before the tree will fall. In the foot-tall tree at right, the back lean is three feet. You don’t want to be stuck after the tree is fell. After the direction of the fall is determined, the back lean amount the tree is going to give should be calculated.
These calculations are very important for situations where a leaning tree is involved. If back lean is alien to you, it is the amount of space from the point marked for the shrubgrinding.barted Reading Time: 6 mins.
May 13, Check where the tree is located and decide where you intend to come down. Make sure there are no cars, buildings, fences, powerlines, and especially people in the area.
Search Advanced search….
Felling a tree with a chainsaw requires planning and should be well thought through even if you have experience using chainsaws. It is a good idea to have somebody with experience on hand especially if it’s your first shrubgrinding.barted Reading Time: 6 mins. Jul 12, Felling a tree with heavy back lean toward a structure. Employed the use of a pull line ( Fiddleblock) combined with bottle jack to overcome back lean.
How to Fell a Tree Against the Lean Remove Branches. Leaning trees often have more branch and leaf growth on the side that is leaning towards the ground.
Notch in Direction of Intended Fall. Cut a notch into the side of the tree in the direction you want it to fall. Make Begin Felling Cut. Begin. Oct 23, If the plumb bob is on the back side of the tree, then you have back lean, and you’ll need to use your wedges and maybe shims to jack the tree over.
To calculate how much you will have to jack the tree to reach the apex where it can begin to fall in the direction you want it to, see the Autumn Tricks of the Trade column.
Information for this article comes from the Game of Logging training program.
Jun 01, Cut in with the back cut leaving a large amount of hinge (wood) on the opposite side of the lean, 8 inches or so. Get the amount of wood you want on the lean side and stop cutting. Put a wedge into the cut on the leaning side, pound the wedge tight.
go to the opposite side of the lean and slowly cut the hinge wood shrubgrinding.barted Reading Time: 9 mins.